INTERMEC 3440 DRIVER

Insert media through the slot at the rear of the printer and thread it over the supply roll post. Print Quality Label, Print Causes the printer to print out the print quality program and model number label. You cannot edit the default page. Advanced 5 mil The printer uses the command set and prints in multiples of 5 mil 0. You can also use memory reset to clear pages and formats, user-defined characters and fonts, configurations, tables, or all of these parameters. If you send a command not used by the printer, it ignores the command. Make sure that you enter the correct command.

Uploader: Tetilar
Date Added: 11 June 2018
File Size: 13.15 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 89605
Price: Free* [*Free Regsitration Required]

Edits or creates a graphic field. Page Printer Reference To position a rotated field, you should keep in mind that the field origin remains on the corner where it was before you rotated the field.

Intermec | Cybarcode, Inc.

Refer to the protocol you are using for your system. Using Test and Service Mode Setting Emulation Mode If you are replacing an Intermec or printer with a printer, you can keep your existing network, hardware, software, and label formats by using Emulation mode. The ,name parameter is optional. There is a table for each type of command specified by a value for t.

  EAH4350 SILENT DI 512MD2 DRIVER DOWNLOAD

Intermec EasyCoder 3440 – label printer – monochrome – direct thermal / thermal transfer Series

This command works with continuous label stock only. Sets the increment value for the selected field.

To print a test label 1. You must define information that you plan to print on the label as a field in the label format.

Intermec EasyCoder Thermal Label Barcode Printer dpi Parallel | eBay

Page 65 – Using ascii control characters or hexade Comments to this Manuals Your Name. This setting lets the printer select a level, between level 2 and level 5, that provides the most efficient error correction of your data. Looking for a tech bargain real soon? The printer ignores this command. This rate in turn affects the throughput of the entire printing process.

Causes the printer to upload all current printer status.

The printer uploads the amount of total storage memory available for formats, fonts, and UDCs. For example, you may need to attach one type of label to a product, and a different label to its container.

Since the printer starts imaging the label so early, the chance that the imaging process will be unable to keep up with the print speed decreases and throughput improves. The printer executes all previous commands before the warm boot takes effect.

  ASUS A8N SLI DELUXE DRIVER

Did you know we have a large staff of programmers who can make our products work with any system, including yours? Use m1 to add to the intercharacter gap value of the font.

Using Test and Service Mode This chapter explains the different procedures you can perform while the printer is in Test and Service mode. The printer supports a wide selection of both direct thermal and thermal transfer media. Intwrmec EasyCoder Developer’s Manual pages.

This table contains suggestions for cleaning the printer. Printhead Size The printhead has elements dots for a total of 4.

Intermec 3440 User Manual

Turns the self-strip option on or off. At the DOS prompt, type this command and press Enter: 344 numeric page ID is n. Page Optimizing Printer Performance DIP switches to their original settings. Environmental Parameters Min Operating Temperature. Selecting the Correct Media Media selection is one of the most important decisions you can make concerning print quality.